500SLZ13 single-stage double-suction center split pump is a single-stage, double-suction, vertical center split vertical direct-coupled centrifugal clean water pump. The flow parts are made of cast iron, the guide bearing is tin bronze, and the shaft is 45# steel, which is used to transport the medium. The temperature is 0℃～80℃, the clear water without solid particles or other liquids with physical and chemical properties similar to water, the inlet pressure is less than or equal to 0.6MPa. It is suitable for factories, cities, mines, power stations, farmland water conservancy projects and other fields.
The appearance and installation drawing of 500SLZ13 model of single-stage double-suction split pump is as follows:
The single-stage double-suction split pump 500SLZ13 is a vertical installation. The suction and discharge ports are in the horizontal direction. The split surface of the split pump is vertically separated on the shaft center line. There is no need to disassemble the inlet and outlet pipelines during maintenance. As well as the motor, you can uncover the pump cover and take out the rotor parts. The upper shaft of the pump adopts rolling bearing, which is lubricated by grease, and there is no cooling cavity on the bearing body. The lower bearing of the pump is a guide bearing, which is lubricated and cooled by the pump's own water. The shaft seal adopts two forms: soft packing seal and mechanical seal. From the motor end to the pump, the pump rotates counterclockwise, that is, the detachable pump cover facing the pump is on the right side of the water inlet and the left side is the water outlet.
