Deep well pump is a pump product that integrates the motor and the pump. It can be immersed in the groundwater well for pumping and conveying water. Therefore, in order to ensure the normal operation of the deep well pump unit, it is equipped with appropriate control. Protect equipment and perform standardized operations. In addition, regular inspection and maintenance work is essential. Once problems are found, they must be resolved in a timely manner.
First of all, the deep well pump unit should be used in a dry and clean environment. The vertical motor should be kept clean and the air duct should be kept clear. It should not be obstructed by some sundries. Do not place heat around it, and avoid direct sunlight. In addition, when it is found that the motor control device has over-current protection or short-circuit protection continuously, it should be carefully checked to find the source of the problem - the motor overload or the protection device setting value is too low, find the source of the problem After that, take corresponding measures to solve it; when it is found that the anti-reverse device of the motor has lost its function, it must be repaired to remove dirt so as not to affect its normal use.
During the operation of the deep well pump, when some small faults occur, it is necessary to stop the inspection. At this time, it is necessary to check the oil level of the motor oil standard. When it is found that the oil level is lower than half of the oil standard, it is necessary to carry out timely After the deactivation of the vertical special motor, when stored in the warehouse, it should be stored in the original packaging, the warehouse should be kept dry and well ventilated; the temperature should be kept above 0 °C; in addition, it should be regularly Check.
