Causes of groove marks on the plate frame of the pipeline booster pump filter press
Pipeline booster pumps will have groove marks on the filter plate after several years of use. This is actually a common phenomenon and can be solved. If you want to solve the groove marks, you must first know the cause of the groove marks. What are the reasons for the groove marks?
Pipeline booster pump
The cause of groove marks on the plate frame of the pipeline booster pump filter press:
In the process of using the pipeline booster pump, for some reason, some groove marks are washed out at the corners. Once the groove marks appear, they will quickly expand until it affects the formation of the filter cake. At first, the filter cake became soft, and then it became semi-sludge, and finally the filter cake could not be formed. Due to the special material of the filter plate of the filter press, it is difficult to repair and can only be replaced with a new one, which causes a high cost of spare parts.
The solution to ditch marks:
1. Clean the grooves, and the fresh surface leaks out, which can be cleaned up with a small saw blade, etc.
2, black and white repair agents are mixed according to the ratio of 1:1
3. Apply the prepared repair agent to the groove, and spread it slightly higher
4. Quickly put on the filter cloth of the filter press, squeeze the filter plates of the filter press together to make the repair agent and the filter cloth of the filter press stick together, and squeeze the grooves at the same time
5. After squeezing for a period of time, the viscose will form naturally and will not change anymore, and it can be used normally at this time.
